707-823-8003

I am always asked, “What is the customer’s responsibility for maintaining a solar system”?  The answer is to check the inverters or performance monitoring to ensure your system is running, and to clean your panels and inverters.

Synergy offers up to a ten year warranty on our solar systems. When we return to sites, many years after the initial installation, without fail, the number one issue affecting system performance is dirty panels.  We clean our floors, cars, and even our pets, but the panels on our roof, or in our yards are neglected.  How much does cleaning really effect performance? Some studies show up to 25% improvement after cleaning (I think this is high but a 7-15% improvement is likely).

On June 19th, Fathers Day, my eldest son Chaz offered to clean my solar panels.  I try to clean my panels really well before May 1st (when Peak Summer rates begin with PG&E), and then hose them off 3-4 times a year before the rains.  This year, the business of life led me to put off this cleaning.  So on Father’s Day, as I sipped my coffee in the back yard, Chaz was up on the roof cleaning my panels.  We do not use any soap (which can leave a soap scum), just plain water and a little elbow grease, or in this case Chaz’s elbow grease.  We use an extendable RV brush with a hose attachment, which works well for us and our roof (see below).

In the picture above you can see my panels were not filthy, they just had dust and pollen accumulation since the last rains.  Below is a picture of a panel from one of our customer visits, showing a typical year’s worth of soiling.

The down slope edges, which trap and allow dirt to build up,  will eventually cover the solar cell, affecting performance.  These lower edges should be scrubbed to remove this build-up.

And then there are those sites that, even though their systems are in the middle of a field, are clean as a whistle when we show up.

Okay, back to my system.  So Chaz is still up on the roof cleaning my panels, and I must say he does a better job of it then I do.  He scrubs off the edges, and the pollen which can be tough.  And he does all this with a smile

They say the proof is in the pudding.  Chaz cleaned my panels in the early morning, 8:30 am, before the panels heated up (hot glass and cool water can cause cracking).  Here is my performance monitoring data, which makes it handy to see the changes cleaning makes.  Before cleaning, the highest daily reading I was getting was 45 KW, with an average of about 42 KW.  In the week after cleaning, I had 4 days exceed 49 KW.  Throw out the one June day we had rain, 6/22/12 (rain in June?), and the average was over 46 KW.  That’s over a 10% improvement.  Thanks Chaz!

One other area that is often forgotten is the inverter.  The only maintenance that needs to be performed here is to make sure the fan vents are clean of dirt and debris.  When the fan input and exit vents get clogged, the inverter has to work harder to stay cool.

Cleaning these vents can go a long way to extending the life of your inverter.

So this ends this blog.  It is always a pleasure to know my system is clean and running at maximum performance.  There is nothing like “Running on Sunshine”.